TM 5-5420-202-20-3
STEERING CONTROL LINKAGE ADJUSTMENT (Sh
20.
Using 9/16 inch wrench to hold steering
r o d end (K), use 9/16 inch wrench to
loosen jarnnut (N).
21.
Using hands, turn control rod (J) clock-
w i s e until control rod (J) is just past
witness hole in steering rod end (K).
Using 9/16 inch wrench, to hold steering
22.
r o d end (K), use 9/16 inch wrench to
tighten jamnut (N).
23.
Using 9/16 inch wrench, turn steering rod
end (F) counterclockwise until screw (E)
w i l l drop freely through clevis (G) and
steering rod end (F).
24.
Using 9/16 inch wrench, install screw (E)
through clevis (G) and steering rod end
(F).
25.
Using socket and torque wrench, tighten
screw (E) to 16 lb-ft (22 N.m).
26.
Using 9/16 inch wrench to hold steering rod end (F), use 9/16 inch wrench to tighten
jamnut (H).
27.
Remove locating pin (A).
Go on to Sheet 7
TA249659
15-36