TM 5-5420-202-20-3
COVER ASSEMBLY (IESCAPE HATCH) REPAIR (LATE MODEL) (Sheet 3 of 5)
11. Remove handle (N) assembly and two lingages
(P) from cover (B).
12. Using 5/8 inch wrench, remove two screws (Q)
separating handle assembly from two linkages.
CLEANING AND INSPECTION:
1.
Using rags, clean surface bolts and linkages
of any excess dirt buildup.
2.
Clean seal groove and seal with dry cleaning solvent and coat with silicone compound.
Inspect all components for damage or wear. Replace as required.
3.
ASSEMBLY:
Place two linkages (A) in position on handle
1.
assembly (B).
2.
Using 5/8 inch wrench, install two screws (C)
securing linkages (A) to handle assembly (B).
3.
Place linkages and handle assembly (A and B)
in position on access cover (D).
Go on to sheet 4
TA249712