TM 5-5420-202-20-3
COVER ASSEMBLY (ESCAPE HATCH) REPAIR (EARLY MODEL) (Sheet 3 of 5)
7.
Remove spring assembly (H) from handle (J).
8.
Using pliers, remove two retaining rings (K).
9.
Remove two links (L) from handle (J).
CLEANING AND INSPECTION:
1.
Using rags, clean all parts of grease and dirt.
WARNING
To prevent personal injury, wear
Dry cleaning solvent P-D-680 is toxic and flammable.
protective goggles and gloves and use only in a well-ventilated area. Avoid contact with skin,
eyes, and clothes and don't breathe vapors. Do not use near open flame or excessive heat. The
flash point for Type #1 Dry Cleaning Solvent is 100%? (38C) and for Type #2 is 138% (50C).
If you become dizzy while using cleaning solvent, get fresh air immediately and get medical aid.
If contact with eyes is made, wash your eyes with water and get medical aid immediately.
2.
Clean seal grove in hatch with dry cleaning solvent.
3.
Inspect all parts for damage or wear. Replace any damaged or worn parts.
ASSEMBLY:
1.
Compare length of links (A) and (B) before
assembly.
2.
Place long link (A) and short link (B) in position
on handle (C) as shown.
TA249719
Go on to Sheet 4
