TM 5-5420-202-20-4
PERSONNEL HEATER REPAIR (Sheet 1 of 8)
PROCEDURE INDEX
I
PROCEDURE
PAGE
Heater Igniter Replacement
Heater Flame Detector Switch Replacement
Ignition Control Replacement
Heater Igniter Replacement (Sheet 1 of 4)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
Inspection
Installation
Test
Flat-tip screwdriver, 1-3/4 in. long
TOOLS:
Flat-tip screwdriver, 8 in. long
Slip joint pliers
Flashlight (Item 73, Appendix D)
SUPPLIES:
Disconnect battery ground cables (page 10-268).
PRELIMINARY PROCEDURES:
Remove right fixed fire extinguisher cylinder (page 20-52)
REFERENCE:
REMOVAL:
1.
Using pliers, unscrew electrical connector
(A). --
2. Pull connector (B) to disconnect cable.
NOTE
Some covers have only one screw on top.
Using screwdriver, remove two screws (C).
3.
4.
Lift cover (D) off heater.
TA248606
Go on to Sheet 2