TM 5-5420-202-20-4
TACHOMETER REAR FLEXIBLE SHAFT REPLACEMENT (Sheet 2 of 6)
REMOVAL:
1.
Using cross-tip screwdriver, remove six
screws (A) from floor plate (B).
Remove floor plate (B).
2.
3.
Using wrench, disconnect rear tachometer
shaft (C) from adapter (D).
4.
Locate where shaft (C) goes into bulkhead
(E).
5.
Using flat-tip screwdriver, loosen clamp (F)
on grommet (G), slip off clamp.
6.
Using flat-tip screwdriver and pliers, pry
out rubber bushing (H) from under grommet
(E). Remove bushing from shaft assembly.
NOTE
Grommet (G) is bonded to bulkhead. If the grommet
does not have to be replaced, go to step 8.
7.
Using screwdriver and pliers, pry out
grommet (G) from bulkhead (E).
Go on to Sheet 3
TA248651
19-26