TM 5-5420-202-20-4
TACHOMETER REAR FLEXIBLE SHAFT REPLACEMENT (Sheet 6 of 6)
NOTE
If grommet (B) was not removed from bulk-
head, go to step 6.
4.
Slide grommet (B) over shaft (A).
5.
Apply adhesive to grommet (B).
6.
Install grommet (B) in position in bulkhead
(c).
7.
Slide clamp (D) over shaft (A) in position
on grommet (B).
8.
Install rubber bushing (E) in position.
Locate tachometer shaft adapter (F) under
9.
driver's compartment floor plate (G).
10.
Using fingers, connect shaft (A) to shaft
adapter (F).
11.
Using screwdriver, tighten clamp (D) on
grommet (B).
12.
Using wrench, tighten shaft (A) to tacho-
meter shaft adapter (F).
13.
Position floor plate (G) with holes alined.
14.
Using screwdriver, install six screws (H).
15.
Install powerplant (page 5-14).
16.
17.
Make sure tachometer works.
18.
Install engine upper access cover (page
End of Task
TA248655
19-30