TM 5-5420-202-20-4
TACHOMETER REAR FLEXIBLE SHAFT REPLACEMENT (Sheet 3 of 6)
8.
While one person holds shaft (C) in crew
compartment, other person locates other
end of shaft (C) through engine upper
access opening.
Attach wire to crew compartment end
9.
of shaft (C).
10.
Person at engine upper access opening
remove shaft (C) by pulling out.
11.
Remove wire from shaft (C) leaving wire
in place for installation.
DISASSEMBLY:
1.
Using slip joint pliers, pull out core (A) approximately 2 inches from tachometer drive
adapter end (B).
2.
Using long round nose pliers, remove slotted washer (C) and gasket (D).
3.
Using slip joint pliers, pull out core (A) from tachometer adapter end (E).
4.
Remove flat washer (F) from adapter end (E).
Go on to Sheet 4
TA248652