TM 5-5420-202-20-4
TACHOMETER REAR FLEXIBLE SHAFT REPLACEMENT (Sheet 5 of 6)
Using steel rule, measure back approximately 10 inches from tachometer adapter end
6.
(B).
From 10 inch mark, wrap shaft (G) with tape 5 inches to the rear until shaft (G) is approxi-
7.
mately 5/8 inch in diameter.
Place heat shrink plastic tubing (H) over tape.
8.
NOTE
Avoid overheating in one spot as plastic tubing melts easily.
Using heat gun, shrink tubing by moving hot air back and forth over entire length of
9.
tubing.
INSTALLATION:
Person in powerplant compartment, attach
1.
wire to powerplant end of shaft (A).
Person in crew compartment, pull on wire
2.
to thread shaft (A) back into position.
3.
Remove wire from shaft (A).
TA248654
Go on to Sheet 6