TM 5-5420-202-20-4
MATERIAL
STOCK
FABRICATING
REQUIREMENT
DESCRIPTION
P/N: 7379233
1 EA QUICK DISCONNECT
CUT EARS OFF QUICK DISCONNECT
NSN: 2520-00-737-9233
FLANGE
FLANGE 1/4" OUTSIDE LIP (6.5"
NOTE: MAY BE
DIA).
SALVAGED
FLANGE.
2.
MACHINE FLAT SIDE UNTIL TOOL
P/N: 10904402
THICKNESS IS APPROXIMATELY 1" TO
6 EA DECK CLIP
1-5/32". (THIS STEP OPTIONAL IF
NSN: 2510-00-020-2331
MACHINE SHOP SERVICES ARE NOT
NOTE: CLIPS MAY
AVAILABLE.)
BE MADE
FROM ANGLE
3.
CUT RING IN THREE PLACES SO THAT
IRON OR
EACH LARGE PIECE HAS 14 SPLINE
FORMED
TEETH.
FROM
1/4" STEEL.
4.
DEBURR SPLINE TEETH EDGES WITH
WIRE BRUSH OR WIRE WHEEL IF
NECESSARY.
5.
USING BENCH GRINDER OR
EQUIVALENT, GRIND APPROXIMATELY
3" RADIUS INTO SHORT ARM OF DECK
CLIP. DEBURR EDGES.
6.
CUT OFF DECK CLIP TO A LENGTH OF
1-5/16".
7.
IF US IN ANGLE IRON. FABRICATE
GUIDE CLIPS
GRIND AS IN STEP 4.
Figure F-4. Final drive adapter hook-up tool (Sheet 1 of 2).
F-4
Change 4