TM 5-5420-202-34
ENGINE REPLACEMENT
Accessory Drive Removal From Replacement Engine (Sheet 6 of 6)
19.
Using 9/16 inch socket, remove
remaining six nuts (AE) and washers
(AF) that secure adapter (AG) and
gasket (AH) to engine damper housing.
Throw away gasket (AH).
20.
Using stud remover/installer, remove
eight studs (AJ).
NOTE
Use clean rags in bottom of engine damper housing to
catch pieces of gasket and lockwire. They must NOT
fall into engine.
21.
Using putty knife, scrape all remaining
traces of gasket material or adhesive
from mounting surface of engine damper
housing.
22.
Using wire cutting pliers, cut and remove
lockwire (AK) from six screws (AL)
that secure adapter (AM) to engine
damper.
Using 13/16 inch socket and extension,
23.
remove six screws (AL) that secure
adapter (AM) to engine damper.
Remove adapter (AM), ring (AN), and coupling (AP) from engine damper.
24.
NOTE
Remove ring (AN) from adapter (AM) only if necessary.
End of Task
3-28