TM 5-5420-202-34
ACCELERATOR CONTROL LINKAGE ASSEMBLY REPAIR (Sheet 3 of 13)
7.
Using pry bar, pull riser housing (C)
from control housing assembly (J).
8.
Pull away gasket (K). Discard gasket
(K).
Using hammer and drive pin punch, remove
9.
pin (L) from lever (M).
10.
Using pry bar, pry lever (M) from shaft
(N) .
CAUTION
Do not remove bearings (R) from
cover (B) or housing (C) unless ID
(inside diameter) is beyond wear
limits (page 4-105).
11.
Pull shaft (N), lever (P), and pin (Q) from
riser housing (C) as an assembly.
12.
Using hammer and drive pin punch, remove
pin (Q) from shaft (N).
Slide lever (P) off of shaft (N).
13.
Go on to Sheet 4
4-101
