TM 5-5420-202-34
ACCELERATOR CONTROL LINKAGE ASSEMBLY REPAIR (Sheet 4 of 13)
14.
If bearing (R) has been removed from
housing (C), remove washer (S) and pre-
formed packing (T) from riser housing (C).
Throw preformed packing (T) away.
15.
Using scribe, mark clevis rod end (U)
and housing (V) to provide a reference
during assembly.
16.
Using scribe, mark clevis with shaft (W)
and housing (V) to provide a reference
during assembly.
17.
Using 7/16 inch wrench, remove bolt
(X) holding tube assembly (Y) to clevis (U).
18.
Move tube assembly (Y) away from clevis (U).
Using 7/16 inch wrench, remove bolt (Z) holding tube assembly (AA) to clevis with shaft
19.
(W).
Move tube assembly (AA) away from clevis with shaft (W).
20.
Pull tube assembly (AA) out of control housing and through shaft (AB).
21.
Go on to Sheet 5
4-102