TM 5-5420-202-34
TRANSMISSION REPLACEMENT (Sheet 2 of 23)
NOTE
Position powerplant on two 10 x 10 x 12
Make sure power plant is level and
inch wooden blocks. Position blocks under
will not move.
each end of engine oil pan.
REMOVAL:
1.
Using 9/16 inch wrench, remove screw
(A) from bracket (B). Remove rod (C)
from bracket (B).
2.
Using 3/4 inch socket, remove
two nuts (D) and washers (E)
securing bracket (F).
3.
Using 3/4 inch wrench, remove nut (G)
and washer (H).
NOTE
It may be necessary to loosen nuts
and move stud back to remove
bracket (F).
Remove bracket (F) and rod (C) as a unit.
4.
5.
Using 3/4 inch wrench, remove two
lockwashers, nuts (J) and stud (K).
Go on to Sheet 3
6-20
