TM 5-5420-202-34
SHIFTING CONTROL SHIELD SUPPORT REPLACEMENT (Sheet 2 of 2)
INSTALLATION:
Position support (A) onto plate (B) and install four screws (C) and washers (D) through
1.
support (A) and plate (B).
Position four lockwashers (E) and nuts (F) onto four screws (C).
2.
Using 1/2 inch wrench to hold screws (C), use torque wrench and 1/2 inch socket to
3.
tighten four nuts (F) to 10-12 lb-ft (13.6 - 16.3 Nm).
Place front shield (G) over rod (H).
4.
Place rear rod (J) and shield (K) in position. Using two 5/8 inch wrenches, connect front rod
5.
(H) and rear rod (J).
Move front shield (G) and rear shield (K) toward front of vehicle until secure.
6.
Position four bolts (L) and four lockwashers (M) through straps (N) into supports (A). Use
7.
torque wrench and 1/2 inch socket to tighten four bolts (L) to 10-12 lb-ft (13.6 - 16.3 Nm).
Connect rear control rod to clevis (TM 5-5420-202-20).
8.
Install right fuel tank (page 4-17).
9.
End of Task
