TM 5-5420-202-34
TRANSMISSION REPLACEMENT (Sheet 1 of 23)
PROCEDURE INDEX
PAGE
PROCEDURE
6-19
Removal
6-29
Cleaning
6-29
Installation
3/4 in. socket with 1/2 in. drive
TOOLS:
1/2 in. combination box and
Universal joint with 1/2 in. drive
open end wrench (2 required)
5 in. extension with 1/2 in. drive
9/16 in. combination box and
1-1/8 in. socket with 3/4 in. drive
open end wrench (2 required)
Ratchet with 3/4 in. drive
3/4 in. combination box and
8 in. adjustable wrench
open end wrench
7/8 in. combination box and
Torque wrench with 3/4 in drive (0-600 lb-ft)
open end wrench
0-813 Nm)
15/16 in. combination box and
Flat-tip screwdriver
open end wrench
Slip joint pliers
1-1/2 in. open end wrench
Hose clamp pliers
1-5/8 in. open end wrench
Snap ring pliers
1/2 in. socket with 1/2 in. drive
Ratchet with 1/2 in. drive
9/16 in. socket with 1/2in. drive
Putty knife
5/8 in. socket with 1/2 in. drive
Pry bar
Hoist (5,000 pounds)
Puller adapter (Item 2, Chapter 2, Section I)
SPECIAL TOOLS:
Slide hammer puller (Item 3, Chapter 2, Section I)
Pinion turning wrench (Item 5, Chapter 2, Section I)
Lifting sling (Item 4, Chapter 2, Section I)
FABRICATED TOOLS: Fabricated wrench (Fig. 1, Appendix D)
Gasket (2 required)
SUPPLIES:
Drain pan (suitable container)
Cotter pins (2 required)
Rags (Item 28, Appendix B)
Preformed packing
Wooden blocks, 10 x 10 x 12 in.
Dry cleaning solvent (Item 12,
(2 required)
Metallic gasket (4 required)
I.D. tags (Item 30, Appendix B)
Lockwashers (11 required)
Gloves (Item 31, Appendix B)
Goggles (Item 32, Appendix B)
PERSONNEL: Two
REFERENCES:
TM 5-5420-202-20
LO 5-5420-202-12
PRELIMINARY PROCEDURE:
Remove powerplant (TM 5-5420-202-20)
Remove engine shroud and supports (TM
5-5420-202-20)
Go on to Sheet 2
Change 2
6-19
