TM 5-5420-202-34
TRANSMISSION REPLACEMENT (Sheet 13 of 23)
CAUTION
When mating transmission to en-
gine, be sure to position electrical wiring
aside to prevent wiring from being caught
between mounting surfaces.
Aline transmission with dowel pins attached to engine, and carefully advance transmission
9.
onto dowel pins until transmission mounting flange is in contact with engine transmission
adapter.
10.
Using fabricated wrench and 5/8 inch socket,
install screw (J), washer (K), and nut (L) on
left and right side of transmission.
Using fabricated wrench or 5/8 inch wrench,
11.
install 17 screws (M), lockwashers (N), and
flat washers (P) that secure transmission
to engine (Q).
12.
Remove lifting sling from transmission.
Push transmission input shaft (H) into
13.
transmission. If engine and transmission
splines do not aline, use 5/8 inch socket
to remove six power takeoff cover screws
(R) and lockwasher (S). Remove cover (T)
and gasket (U).
Go on to Sheet 14
Change 2
6-31
