TM 5-5420-202-34
TRANSMISSION REPLACEMENT (Sheet 14 of 23)
14. Using pinion turning --wrench, turn transmission until splines aline and shaft (H) will slide in and seat
properly.
15. Remove pinion turning wrench.
16.
Using snap ring pliers, install retaining ring (G) on input shaft (H).
17.
Position gasket (F) onto plug (E) and, using 7/8 inch socket and torque wrench, tighten
plug (E) to 50-60 lb-ft (68-81 Nm).
18.
Position power takeoff gasket (U) and cover (T) on transmission housing and, using 5/8
inch socket, install six screws (R) and washers (S).
19.
Install or connect transmission wiring
harness (TM 5-5420-202-20).
Go on to Sheet 15
6-32 Change 2
