TM 5-5420-202-34
FINAL DRIVE REPAIR (Sheet 6 of 30)
CAUTION
Protect threads of studs (S) with
several layers of tape.
23.
Place crowbar between output shaft
studs (S) to prevent shaft from turning
and stabilize carrier during nut
removal.
NOTE
Late model nut does not have a
lockwasher.
24.
If required, use hammer and chisel to
bend tangs of lockwasher away from
nut (T).
25.
Place special box wrench onto nut (T).
CAUTION
Support end of reactor
bar
against fixtured object (wood
block).
DO NOT rest against
pinion gear (F).
26.
Using PD 1201 torque wrench with 3/4-
inch drive and reactor bar, loosen nut
(T).
27.
Remove nut (T) and lockwasher if
present. Throw nut and lockwasher
away.
Go on to Sheet 7
7-6 Change 2
