TM 5-5420-202-34
FINAL DRIVE REPAIR (Sheet 8 of 30)
Using hammer and brass drift or wood
32.
block, remove bearing race (X) (early
model) or bearing (Y) (late model) from
case (Q).
CAUTION
Early model bearing and race
must be replaced as part of up-
grade.
NOTE
Do not replace any parts until
after bearing pocket/bore checks
are made.
33.
Make sure carrier (P) gasket surface (Z)
and bearing shelf (AA) are clean prior
to positioning parallel straight bar.
Position parallel straight bar on gasket
34.
surface (Z) across bearing pocket of
carrier (P).
Using micrometer depth gage, measure
35.
from - top of parallel bar to bearing shelf
(AA) of carrier (P) and record reading.
Repeat measurement a minimum of
36.
four times in four equally spaced
points. Record measurements.
Measure thickness of parallel bar and
37.
subtract from recorded measurements.
If all measurements are between 1.347
inches and 1.357 inches, go to step 39.
Go on to Sheet 9
7-8 Change 2
