TM 5-5420-202-34
FINAL DRIVE REPAIR (Sheet 11 of 30)
50.
Using bearing puller or hammer and
drift, remove bearings (AF - early
model) or bearing inner races (AG - late
model) from pinion (F). Throw away
pinion bearings and races.
51.
Pinion bearings (AF or AG) must be
replaced as part of overhaul.
52.
Remove spacer (AH) from output shaft
(AJ).
53.
Inspect spacer (AH) for damage or
pitting.
54.
If unserviceable, discard, or fabricate
special tool.
NOTE
Spacer (AH) may be used to fabri-
cate the special tool required to
seat output shaft and drive gear
bearings (Figure 4, Appendix D).
Go on to Sheet 12
Change 2 7 - 1 1
