TM 5-5420-202-34
BRAKE SLAVE CYLINDER REPAIR (Sheet 5 of 6)
5.
Assemble new tube (M), new spring (N), retainer
(P), and tube (Q) into slave cylinder (D).
Compress tube (Q) into slave cylinder (D) until
holes in slave cylinder (D) aline with holes in
tube (Q).
CAUTION
To ensure proper installation, hold
spring (N) in position while performing
step 6.
6.
Using 1/2 inch wrench, install and tighten two
screws (R) securing tube (Q) in slave cylinder (D).
7.
Remove slave cylinder (D) from vise.
Thread 3/8-16 UNC 2B screw (S) into
8.
end of mounting nut (T). Using 9/16
inch wrench, tighten screw (S).
Secure mounting nut (T) (head end) in
9.
vise.
Using screwdriver,
tighten pellet (U)
10.
until 12 to 16 lb-in
(.90 to 1.80 Nm) is
required to remove
screw (S) from nut
(T). Remove screw
(S) from nut (T).
Go on to Sheet 6
8-11
Change 2
