TM 5-5420-202-34
BRAKE SLAVE CYLINDER REPAIR (Sheet 2 of 6)
CAUTION
Hold tube (D) in position while removing screws as spring is
compressed in cylinder.
2.
Using 1/2 inch wrench, remove two screws (C) holding tube (D) in slave cylinder (A).
3.
Remove tube (D), retainer (E), spring (F), and tube (G) from slave cylinder (A). Throw
tube (G) and spring (F) away.
4.
Using 3/8 inch wrench, remove bleeder
valve (H) from slave cylinder (A).
Using 1 inch wrench, remove plug (J)
5.
and preformed packing (K). Throw away
packing (K).
6.
Move slave cylinder in vise to expose
pin (L).
7.
Using drift punch and hammer, remove pin (L) and remove slave nut (M) from slave cylinder
(A).
Go on to Sheet 3
8-8