TM 5-5420-202-34
TRACK SUPPORT AXLE ASSEMBLY REPAIR (NUMBER 1 THROUGH 3 LEFT AND RIGHT)
(Sheet 2 of 2)
Examine bearings surface of axle (A) for cuts or marks made during removal of spacer (B).
4.
Using crocus cloth (Item 3, Appendix B), smooth any cuts or marks made on axle (A) during
5.
removal.
Remove axle assembly from vise.
6.
ASSEMBLY:
Position axle assembly (A) on arbor press.
1.
Position new spacer (B) over axle (A) as
2.
shown.
Position 2-9/16 inch inside diameter drive
3.
collar over axle (A) onto spacer (B) and, using
arbor press, drive spacer (B) onto axle (B).
NOTE
Seat spacer firmly all the way down on
the axle shaft
End of Task
9-23
