TM 5-5420-203-14
c. Assembly of the Bridge Separated into Eight Sections - CONT
(b) Place the quadrant (1) in position so that it rests on the installed quadrant hinge pins (2)
and (3).
(c) Close the two coupling hinges (4) and (5). Insert one quadrant hinge pin (6) through each
hinge from the center of the bridge outward. Install pin retainer (7) through quadrant
hinge pin.
(d) Insert a second quadrant locking pin (8) from the rear, passing through the center pin (2)
and out between the hinges (4) and (5). Install second retainer (9) in quadrant locking
pin (8).
(e) Repeat steps (c) and (d) for opposite side.
(f) Install a third quadrant locking pin (10) through the two angular plates (11) passing over
installed pin (8). Install retainer (12) in pin (10). Repeat for opposite side.
(22) Quadrant Struts and Securing Hardware.
(a) Install first of two quadrant struts (1) into strut mount (2) located at the top of quadrant
(3).
(b) Position pin retainer of cable
retainer to not get in the way of
bolt (4).
(c) Insert bolt (4) through hole in
strut mount (2), through slot in
strut (l), and extend out through
bottom of strut mount.
(d) Thread nut (5) on bolt (4) until
snug. Place locking retainer pin
(6) through hole in bolt (4).
Ensure retainer is secure in bolt.
2-27