TM 5-5420-203-14
DECK CURB REPLACEMENT
TOOLS/EQUIPMENT
General Mechanics Tool Box SC 5180-90-N26
SUPPLIES:
EQUIPMENT CONDITIONS:
None.
PERSONNEL:
Two
REMOVAL
REMOVE DECK CURB (3).
NOTE
Bolts securing center section deck curbs are
installed from-the bottom side up and will fall
out if not held. The two bolts located on
either end of curb are shorter in length than
those in the middle.
a. Remove five nuts (1) from five bolts (2)
securing deck curb (3) to center, section (4).
b. Remove five lock washers (5) from five bolts
(2). Remove five bolts ( 2) with five flat
washers (6) installed from center section (4).
Remove deck curb (3) from center section (4).
Discard lock washers.
INSTALLATION
INSTALL DECK CURB (3).
NOTE
Deck curbs (7) have extra mounting holes
located in base for use in allowing mounting
on either side of center sections.
a. Position deck curb (3) so holes aline in
c. Install five new lock washers (5) on
curb and center section (4).
bolts (2). Thread five nuts (1) on bolts
(2).
b. Install five flat washers (6) on five bolts
(2). Insert bolts from the bottom of the
d. Tighten five nuts (1) on bolts (2).
END OF TASK
3-16
