TM 5-5420-203-14
RAMP CURB REPLACEMENT
TOOLS/EQUIPMENT
General Mechanics Tool Box SC 5180-90-N26
SUPPLIES:
Lock Washer (item 5, Appendix E) (6 required)
EQUIPMENT CONDITIONS:
None.
PERSONNEL:
Two
REMOVAL
REMOVE RAMP CURB (4).
a. Remove four nuts (1) and four bolts
(2). from ramp curb (3). Remove four lock
washers (4) from bolts (2). Discard lock
washers (4).
b. Remove bolt (5) with attached lock washer
(4) from curb (3). Remove ramp curb (3).
Discard lock washer (4).
INSTALLATION
INSTALL RAMP CURB (4).
a. Place ramp curb (3) on end ramp (6). Aline
holes in ramp curb with those in end ramp.
b. Thread bolt (5) with attached flat washer into
threaded socket in end of curb (3) and end ramp
(6) and tighten.
c. Insert four bolts (2) from the bottom side of end
ramp (6) Up through end ramp and ramp curb (3).
d. Install four new lock washers (4) on installed
four bolts (2).
e. Thread four nuts (1) on four bolts (2) and
tighten.
END OF TASK
3-18
