TM 5-5420-203-14
END PANEL CURB REPLACEMENT
T O O L S/ E QU I P M E N T
General Mechanics Tool Box SC 5 180-90-N26
SUPPLIES:
Lock Washer (item 5, Appendix E) (5 required)
EQUIPMENT CONDITIONS:
None.
PERSONNEL:
Two
REMOVAL
REMOVE END PANEL CURB (3).
NOTE
End panel curbs have extra mounting holes
located in base for use in allowing mounting
on either side of end panels.
a. Remove four nuts (1) from four bolts (2)
securing end panel curb (3) to end panel (4).
b. Remove four lock washers (5) from four
bolts (2). Remove four bolts (2) with four flat
washers (6) installed from end panel (4).
Remove end panel curb (3) from end panel
(4). Discard lock washers (5).
c. Remove nut (7) and lock washer (8) from
short bolt (9). Remove bolt (9). Discard lock
washer.
d. Remove flat washer (10) from bolt (9).
INSTALLATION
INSTALL END PANEL CURB (3).
a. Position end panel curb (3) so holes aline in
d. Tighten four nuts (1) on bolts (2).
Tighten four nuts (l).
curb and end panel (4).
e. Place flat washer (10) on bolt (9). Install
b. Install four flat washers (6) on four bolts
bolt (9) in end panel and curb (3) from
(2). Insert bolts from the bottom of the deck
bottom up.
extrusions up as shown.
f. Install new lock washer (8) on bolt (9).
c. Install four new lock washers (5) on bolts
Thread nut (7) on bolt (9). Tighten nut/
(2). Thread four nuts (1) on bolts (2).
bolt assembly.
END OF TASK
3-17
