TM 5-5420-203-14
FAR-SHORE CENTER SECTION TRANSVERSE BRACE REPLACEMENT (Sheet 3 of 4)
m. Remove three retainers (21) securing three
nuts (22) to three bolts (23) securing cable
beam (15) to far-shore center section clip angles.
n. Repeat for opposite side of cable beam (15).
Slide beam (15) clear of clip angles and
quadrant struts (19 and 20). Set beam (15)
aside.
o. Remove four bolts (24) securing transverse
brace (25) to clip angles of center sections.
Remove transverse brace (25).
INSTALLATION
INSTALL FAR-SHORE CENTER SECTION TRANSVERSE BRACES (2 and 25).
NOTE
.Transverse braces can be mounted on either side of clip angles of center sections.
Be sure opposite side of brace (25) falls on the same side of the center section Clip
angles.
q
a. Position transverse brace (25) in position as shown on one side of clip angles.
b. Install four bolts (24) securing transverse brace in position. Tighten bolts (24).
c. Slide transverse brace (25) over cylinder cap end.
d. Slide cable beam (15) in position on clip angles on center sections. Be sure connecting ends of
struts (19 and 20) fit in recessed slots of beam (15).
e. Aline the holes in beam (15) with those in the clip angles.
f. Install six bolts (23) in cable beam (15).
g. Thread six nuts (22) on six bolts (23). Tighten nuts (22).
h. Install six retainers (21) in six bolts (23).
i. Secure transverse brace (25).
NOTE
It maybe necessary to shake quadrant (not shown) up and down using lifting device in
order to a.line strut mounting holes.
j. Install two bolts (18) through cable beam (15) securing struts (19 and 20) in position.
k. Thread two nuts (17) on two bolts (1 8). Tighten nuts (17).
1. Install two retainers (16) in two bolts (18).
3-41
