TM 5-5420-203-14
FAR-SHORE CENTER SECTION TRANSVERSE BRACE REPLACEMENT (Sheet 4 of 4)
NOTE
A second crew member is required for
the following task.
m. Insert flat end of equalizer plate (14) into
cavity located on cable beam (15). Install
equalizer plate pin (13) in cable beam (15)
securing quaker plate and attached cables (11).
n. Install equalizer plate pin retainer (12) in
pin (13).
NOTE
The direction
of the rotation of the
cable strands are critical. The left cable
is not designed for use on the right and
vice versa Note the rotation of the
strands of the cable when replacing
cables, check the current placement
with Detail A and B and ensure they
are installed properly.
o. install cable retainer (9) in flanges (10) of
quadrant (5) securing cables (11) in
position.
P, Install two pins (8) through flanges
(10) locking cable retainer (9) in
position.
q. install two pin retainers (7) in pins
(8). If second two pin retainers (7)
were removed, install second two pin
retainers (7) in opposite ends of pins (8).
r. Position transverse brace (2) on one side
of clip angles.
s. install four bolts (1) securing brace (2).
Tighten bolts.
END OF TASK
3-42
