TM 5-5420-203-14
CENTER SECTION DECK EXTRUSION REPLACEMENT (Sheet 2 of 3)
d. Remove nut (7), lock washer (8), and flat
washer (9), from screw (10) securing flat
washer (11) in position between deck extrusions
(5 and 12). Discard lock washer.
e. Slide screw (10) back until it releases flat
washer (spacer) (11).
f. Remove flat washer (13) and screw (10) from
deck extrusions (5 and 12).
g. Repeat steps d. thru f. as necessary to remove
deck extrusions.
NOTE
Steps h. and i. are for removal of the lifting
bar (14).
h. Remove two nuts (15) and two lock washers
(16) securing lifting bar (14) in position.
Discard lock washers.
i. Remove lifting bar (14) and two screws (17)
from deck exTRUsion (5).
INSTALLATION
INSTALL CENTER SECTION DECK EXTRUSION
(5 AND 12).
a. Inspect replacement deck extrusion to be sure it
is the correct replacement and all mounting holes
aline. Position deck extrusion under curb, if
mounted.
b. Place flat washer (13) on screw (10). Position
flat washer (spacer) (11) between deck
holes.
Install screw (10) with flat washer (13) through
c.
deck extrusion (5), flat washer (spacer) (11) and
deck extrusion (12).
d.
Install flat washer (9) and new lock washer (8)
on screw (10).
e. Thread nut (7) on screw (10). Tighten nut (7).
3-69