TM 5-5420-203-14
CENTER SECTION DECK EXTRUSION REPLACEMENT (Sheet 3 of 3)
f. Place flat washer (6) on screw (4). Install screw
(4) from bottom side up through support girder
and deck extrusion (5 or 12).
g. Install flat washer (3) and new lock washer (2)
on installed screw (4). Thread nut (1) on screw
(4). Tighten nut (l).
h. Repeat as necessary for remaining mounting
hardware.
i. Position lifting bar (14) on underside of deck
extrusion as shown.
j. Install two screws (17) from the topside down
through mounting holes in deck extrusion and
lifting bar (14).
k. Install two new lock washers (16) and two
nuts (15) on two screws (17). Tighten
nuts (15)0
1. Repeat as necessary for remaining hardware.
END OF TASK
3-70
