TM 5-5420-209-12
4-29. Rear Winch Assembly. - Continued
(24)
(25)
(26)
(27)
(28)
(29)
(30)
(31)
(32)
(33)
(34)
(35)
(36)
(37)
Remove primary planet assembly (49).
Remove bushing (50).
Remove plug (51).
Drive pin (52) into planet pin (53) and remove planet pin (53), and gear (54) from hub (55).
Press bearing (56) from gear (54).
Repeat Steps (26) through (28) for remaining gears.
Remove thrust pad (57) and preformed packing (58).
Remove preformed packing (59), oil seal (60), ring seal (61), and retaining ring (62).
Remove four screws (63), washers (64), and nuts (65) and remove primary drive housing (66).
Remove drum (14) from base (67).
Remove bearing (68), seal ring (69), oil seal (70), and preformed packing (71).
NOTE
Perform Step (35) only if drum bearing (72) is to be removed.
Remove drum bearing (72).
Remove retaining ring (73) and bearing (74).
Remove seal ring (75), oil seal (76), and preformed packing (77).
4-80
