4-29. Rear Winch Assembly. - Continued
(11) Install final drive housing (8) and secure with four screws (15), washers, and nuts (17). Torque nuts to
75 lb-ft (101.6 Nm).
(12) Turn base (67) on its side.
NOTE
There should be approximately 0.0625 in. (0.1587 cm) of clearance between drum (14) and final drive
housing (8) when drum is properly seated.
(13)
(14)
(15)
(16)
(17)
Mall drum (14) with splined end toward final drive housing (8) and gently tap drum until the retaining ring
on bearing is properly seated.
Install retaining ring (62) in first ring groove in primary drive housing (66).
Install primary drive housing (66) and secure with four screws (63), washers (64), and nuts (65). Tor que
screws to75 lb-ft (101.6 Nm).
Lubricate preformed packing (59) and oil seal (60) and install in ring seal (61) with lip of oil seal (60) facing
away from center bore of ring seal (61).
Install assembled items in primary drive housing (66) and gently tap seal ring (61) until seated against retain-
ing ring (62).
4-84
TM 5-5420-209-12
