4-29. Rear Winch Assembly. - Continued
(29) Install gear spacer (44) on primary sun gear (34) with slotted end away from gear on prirnary sun gear (34).
(30) Install roller bearing (43), flange down, over primary sun gear (34) until it rests against gear spacer (44).
(31) Install retaining ring (42) in brake hub (41).
(32) Install brake hub (41) on primary sun gear (34) and seat on roller bearing (43).
NOTE
When cam locks are properly installed, the brake hub (41) will only rotate freely in the clockwise direction.
(33)
(34)
(35)
(36)
(37)
(38)
(39)
(40)
Install sixteen cam locks (37) and one brass cam lock (38) between primary sun gear (34) and bore of brake
hub (41).
Install garter spring (39).
Install retaining ring (40).
Install roller bearing (35) and seat it on brake hub (41) flange.
Remove sun gear (34) with twisting motion.
Remove roller bearing (43).
Install garter spring (36), roller bearing (43), and sun gear (34).
Check rotation of brake hub (41). The brake hub (41) should rotate freely in the clockwise direction, and
lock-up in the counter clockwise rotation. If brake hub (41) does not operate properly, the cam locks are incor-
rectly installed.
4-88
TM 5-5420-209-12
