4-29. Rear Winch Assembly. - Continued
(41) Install brake ring (48) in primary drive housing (66).
(42) Install retaining ring (47) on brake hub (41).
(43) Install brake subassembly (33) in brake ring (46) and install retaining ring (45).
(44) Install assembled items into primary drive housing (66) making sure primary sun gear (34) engages with pri-
mary planet assembly.
CAUTION
Do not force motor assembly into housing. If resistance is felt, remove motor and investigate the cause
of resistance.
(45)
(46)
(47)
(48)
(49)
(50)
(51)
(52)
Install spacer (32) and motor (23) in primary drive housing (66).
Mall retaining ring (30).
Aline mark on motor (23) with mark on primary drive housing (66).
Lubricate preformed packing (31) with grease and install on motor (23) and relubricate preformed packing
(31) with grease.
Install brake springs (27) in same pattern as they were removed.
Lubricate preformed packing (29) with grease and install on spring cover (23) and relubricate preformed
packing (29) with grease.
Install 12 screws (26) and washers (28) and finger tighten.
lighten each screw (26) one half turn each in either a clockwise or counterclockwise sequence until all 12
screws are torqued to 35 lb-ft (47.4 Nm).
TM 5-5420-209-12
4-90
