4-29. Rear Winch Assembly. - Continued
(40)
(41)
(42)
(43)
(44)
(45)
(46)
(47)
(48)
(49)
(50)
(51)
Position side plate (27) on base (42) and secure with 10 screws (22) and washers (23).
Install winch drum (41).
Aline position of brake port vent as noted during disassembly and secure with six screws (20) and washers
(21).
Install tie bar (35) and secure with screw (24), lockwasher (25), and nut (26).
NOTE
Winch assembly should be positioned on motor drive end for next procedure.
Place straight edge between tie bar (35) and base (42) and install as many shims(5) as will fit between bear-
ing support (31) and straight edge.
Install side plate (30) and secure with ten screws (28) and washers (29).
Install eight screws (36) and lockwashers (37).
Install screw (32), lockwasher (33), and nut (34).
Install input gear assembly (9) and ensure it engages the sun gear of primary planet carrier
assembly.
Install motor adapter (8) and secure with two screws (6) and washers (7).
Install shim (5), gasket (4), motor (3), and secure with four screws (1) and washers (2).
Refer to LO 5-5420-209-12-1 and lubricate winch.
4-112
TM 5-5420-209-12
