TM 5-5420-209-12
4-30. Winch Motor Assembly (Used on Winch Model 11-S-EC). - Continued
(16)
(17)
(18)
(19)
(20)
(21)
(22)
(23)
(24)
(25)
(26)
Install end cover (31) in brake piston (22), ensure packings (24) and (23) do not get pinched, and backup
washers (26) and (25) do not protrude.
Install washer (11) in outside groove of short bushing (9).
Install two washers (8) in inside groove of short bushing (9).
Lubricate packing (7) with grease and install in short bushing (9).
Lubricate packing (10) with grease and install in short bushing (9).
Install short bushing (9) in center bore of port end cover (2) with thick walled end of short bushing (9) entering
first.
Install needle bearings (6) in port end cover (2).
Install seal (4) in thrust plate (3) and lubricate with grease.
Install thrust plate (3) over needle bearings (6) in port end cover (2) until 0.0375 in. (0.07937 cm) clearance
remains between thrust plate (3) and port end cover (2).
Install four seals (5) and finish installing thrust plate (3) until flush with service of port end cover (2).
Trim away any excess seal (5).
Figure 4-28. Winch Motor, Reassembly (Sheet 1 of 2).
4-121
