2-8. Cable Tensioner Assembly. - Continued(6) Remove retaining ring (19) and remove rope pulley (20) from planetary flange (21).(7) Remove fitting key (22).(8) Remove six screws (23) and tooth wheel (24) from rope pulley (20).(9) Remove retaining ring (25) and remove arm (26) from housing (12).(10) Unscrew pin (27) from housing (12).(11) Remove pin (28), two bearings (29) and pulley (30) with tooth wheel (31) attached.(12) Remove six screws (32) securing tooth wheel (31) to pulley (30).(13) Remove plug (33) and seal (34) and discard seal.(14) Remove eight screws (35) and cover (36) from housing (12).(15) Remove planetary flange (21) with screw (37), washer (38), drive shaft (39), retaining ring (40),bearing (41), sealing ring (42), bearing (43) and bearing (44) attached.(16) Remove internal geared wheel (45) from housing (12).(17) Remove radial sealing ring (46) and bearing (47) from housing (12).(18) Remove screw (37), washer (38) and drive shaft (39) from flange (21).(19) Remove retaining ring (40), bearing (41), sealing ring (42), bearing (43) and bearing (44) fromflange (21).Dry cleaning solvent, PD-680, used to dean parts is potentially dangerous to personnel andproperty. Avoid repeated and prolonged skin contact. Do not use near open flame or exces-sive heat. Flash point of solvent is 100°F-138°F (38°C-60°C).(20) Clean all components with dry cleaning solvent and dry thoroughly.(21) Inspect all threaded parts for damaged threads and replace if damaged.(22) Inspect retaining ring grooves for scratches, burrs and damage.NOTETooth wheels are replaced as a set.(23) Inspect tooth wheel, gears and shaft for cracks, worn or missing teeth, and replace if damaged.2 -7TM 5-5420-209-34
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business