ARMY TM 5-5420-212-10-1 MARINE CORPS TM 08676A-10/1-1 TABLE 2-1.  Preventive Maintenance Checks and Services Daily Schedule (visual) - Bridge Assembled. ITEM ITEM TO BE PROCEDURES No INSPECTED 1 Bridge a.   Inspect approaches and exits for excessive wear.  Ensure marker lights are visible and secure. b.   Check condition of ground bearing/packing for damage or erosion at near bank and far bank. c.   Check anchorages are secure. d.   Check bridge position has not shifted. e.   Equipment not ready/available approaches and exits have excessive wear and are not easy marked, ground bearing/packing and anchorages are insecure, or bridge has shifted excessively. 2 Bridge Marker Guide a.   Check marker guide is in position and secure. b.   Check for obvious damage. 3 Curb a.   Check curb is in position and secure. 4 Deck Unit a.   Check for obvious damage, cracks or indentations. b.   Check tread pattern is not excessively worn. c.   Check deck units are in place and secure. d.   Equipment not read/available if deck unit is not securely in place or is cracked or broken. 5 Ramp Unit a.   Check for obvious damage, cracks or indentations. b.   Check tread pattern is not excessively worn. c.   Check ramp units are in place and secure. d.   Equipment not read/available if ramp unit is not securely in place or cracked or broken. 6 Top Panel a.   Check for obvious damage, cracks or indentations. b.   Check tread pattern is not excessively worn. c.   Equipment not ready/available if top panels show signs of obvious damage. 7 Junction Panel a.   Check for obvious damage, cracks or indentations. b.   Check tread pattern is not excessively worn. c.   Equipment not ready/available f junction panels show signs of obvious damage. 8 End Taper Panel a.   Check for obvious damage, cracks or indentations. Bankseat Beam b.   Equipment not ready/available f components show signs of obvious Sway Brace damage. Bottom Panel Anchor Assembly Post Tensioning Assy Reinforcing Links 9 Pins and a.   Where pins and clips are visible, check they are in place and have not Retainer Clips vibrated loose. b.   Equipment not ready/available pins or clips are not in place. 2-2