ARMY TM 5-5420-212-10-1
MARINE CORPS TM 08676A-10/1-1
(4)
Avoid excessive packing such that the end of bridge is too high causing the ramps to be at a steeper
gradient than the end of bridge. Cut, fill or pack to ensure ramps sit properly at ground level.
4-24.
LAYING RAMPS
a.
General
The near bank ramps are fitted to the bridge first, then after the decking is laid, the far bank ramps are fitted. The
drill is the same for both ends
b.
Procedure
(1)
Fit ramps in pairs, starting with the outer pair.
(2)
Hook ramp one about 9 in (23 cm) inboard from final position, then slide them sideways into place. This
will engage the anti-lift lugs.
4-90
