ARMY TM 5-5420-212-10-1
MARINE CORPS TM 08676A-10/1-1
8-15 ADJUSTABLE SUPPORT (Pins and Chains)
This task covers:
a.
Removal
b.
Service/Repair
c.
Installation
INITIAL SETUP:
Tools Required
8 inch pliers
6 inch flat file
1 lb ball peen hammer
6 inch screwdriver
5/16 inch diameter drift pin
Materials Required
Clean cloths
Lubricating oil (2, Appendix D)
Equipment Conditions
Pins and chain connected to component.
a.
Removal
(1)
Straighten prongs of cotter pin (1) in support pin handle (2) with pliers and screwdriver, then remove
cotter pin from support pin handle.
(2)
Straighten prongs of cotter pin (3) in adjustable support (4), then remove cotter pin and chain from
adjustable support.
(3)
Using drift pin and hammer, drive out the spring pin (5) securing the handle to the support pin (6).
8-30
