ARMY TM 5-5420-212-10-1
MARINE CORPS TM 08676A-10/1-1
8-17 FIXED SUPPORT (Pin and Trunnion)
This task covers:
a.
Removal
b.
Inspection
c.
Pre-Load Check of Bearing
INITIAL SETUP:
Tools Required
1 lb ball peen hammer
Drift pin
8 inch pliers
6 inch flat file
Materials Required
Crocus cloth (25, Appendix D)
Equipment Conditions
Component in upright position on raised, flat surface.
a.
Removal
(1)
Straighten prongs of cotter pins (1) with pliers and screwdriver, then remove from pin (2).
(2)
Tap out pin (2) using drift pin and hammer.
(3)
Lift out trunnion (3) from fixed support (4).
8-34