TM 5-5420-226-20-2
CRANKCASE BREATHER TEE AND REAR TUBE REPLACEMENT (Sheet 6 of 6)
NOTE
P e r f o r m steps 11 through 15 only if your vehicle is equipped
w i t h a 2DA engine.
11.
Install new hose (Q) and clamps (R) onto e n g i n e breather tube extension (S).
I n s t a l l end of engine breather tube extension (S) into hose (M). Install hose end of breather
12.
t u b e extension (S) onto left ejector tube (T).
Slide clamps (R) and (N) over hoses (M) and
13.
( Q ) . Using screwdriver, tighten clamps (R)
and (N).
I n s t a l l clamp (U) onto engine breather tube
14.
e x t e n s i o n (S).
U s i n g two wrenches, install screw (V)
15.
and new self-locking nut (W) to secure
c l a m p (U) to bracket on left ejector tube
(T).
16.
I n s t a l l rear engine cooling fan (page 9-57).
17.
I n s t a l l transmission shroud (page 9-6).
18.
I n s t a l l top deck (page 16-23).
End of Task
Change 2
