TM 5-5420-226-20-2
FUEL SHUTOFF CABLE ASSEMBLY REPLACEMENT (Sheet 7 of 15)
Wrap and securely
18.
tie 8 to 10 feet of
wire (AH) around front
end of cable assembly (H).
NOTE
Wire (AH) will be used during instal-
lation to thread cable assembly
through bulkhead connector (V) and
guide tube (AJ).
Using two persons, remove cable assembly (H) by slowly pulling cable assembly (H) into
19.
rear compartment allowing wire (AH) to thread through grommet (U), bulkhead connector
(V), and guide tube (AJ).
20.
Untie wire (AH) from front of cable assembly (H) and remove cable assembly (H) from
hull. Leave wire (AH) in hull for cable assembly installation.
TA107778
Go on to Sheet 8