TM 5-5420-226-20-2
FUEL-WATER SEPARATOR FLUID PRESSURE FILTER ASSEMBLY REPLACEMENT (Sheet 4 of 7)
Using 7/16 inch wrench, turn bleed cap (K)
counterclockwise until loose. Let fuel-water
filter drain.
Using 1/2 inch socket and extension, remove
three capscrews, lockwashers, and flat
washers (L).
Remove clamp (M) from filter (C).
NOTE
It may be necessary to tap sensor
just above the threaded portion
of the adapter with a 1/8 inch
punch and hammer.
Using 1/2 inch socket and extension, loosen
15.
capscrew (N) to provide movement to fuel-water
separator filter (C).
Using 9/16 inch wrench, remove upper sensor (P)
16.
from fuel-water separator filter (C).
Tag upper sensor (P) to make sure of correct
17.
installation.
Using 9/16 inch wrench, remove lower sensor (Q)
18.
from fuel-water separator filter (C).
Tag lower sensor (Q) to make sure of correct
19.
installation.
VIEW FROM BOTTOM OF FILTER
(SHOWN REMOVED FROM E N G I N E
FOR CLARITY)
Go on to Sheet 5
TA107819
7-212