TM 5-5420-226-20-2
FUEL-WATER SEPARATOR FLUID PRESSURE FILTER ASSEMBLY REPLACEMENT (Sheet 6 of 7)
Using 1/2 inch socket and extension, install
two capscrews, lockwashers, and flat
washers (E).
Position clamp (F) around sensor wires
(C) and (D) and, using 1/2 inch socket,
install capscrew, lockwasher, and flat
washer (G) and clamp (F) onto fuel-water
separator filter (H).
Using 1/2 inch socket, tighten capscrew (B).
VIEW FROM BOTTOM OF FILTER
(SHOWN REMOVED FROM ENGINE
FOR CLARITY)
8.
Using 9/16 inch wrench, install condensate
drain line (J) to elbow (K).
Remove plastic barrier material and tape
9.
from openings of fuel inlet line (L) and
elbow (M).
10.
Using 7/8 inch wrench, install fuel line (L)
to elbow (M).
11.
Remove plastic barrier material and tape from
openings of fuel outlet line (N) and elbow (P).
12.
Using 7/8 inch wrench, install outlet line (N)
to elbow (P).
Go on to Sheet 7
TA107821
7-214