TM 5-5420-226-20-2
MANIFOLD HEATER OPERATIONAL CHECK (Sheet 1 of 2)
SPECIAL TOOLS: Ground hop kit (Item 30, Chapter 3, Section I)
PERSONNEL: TW O
PRELIMINARY PROCEDURE:
Remove powerplant (page 5-2)
OPERATIONAL CHECK:
1.
Using ground hop kit, prepare
engine for powerplant test
run (page 5-25).
2.
Have first person positioned
near intake manifold heater
tube (A) to check heat on
tube (A) when engine is
started.
NOTE
This check must be made after
any part of the manifold heater
system is replaced.
3.
Have second person sit on driver's seat
(B). Set FUEL PUMPS switch (C) to OFF
(down) position and MASTER BATTERY
switch (D) to ON (up) position on
master control panel (E).
Go on to Sheet 2
TA107905