TM 5-5420-226-20-3
STARTER REPLACEMENT (Sheet 1 of 7)
PROCEDURE INDEX
PAGE
PROCEDURE
Removal
Installation
15/16 in. combination box and
TOOLS:
Ratchet with 1/2 in. drive
open end wrench
10 in. extension with 1/2 in. drive
Diagonal cutting pliers
1/2 in. socket with 1/2 in. drive
Flat-tip screwdriver
9/16 in. socket with 1/2in. drive
Torque wrench with 3/8 in. drive
3/4 in. socket with 1/2 in. drive
(0-200 lb-in.)
1/2 in. combination box and
3/4 in. socket with 3/8 in. drive
open end wrench
Slip joint pliers
3/4 in. combination box and
open end wrench
SPECIAL TOOLS: Ground hop kit (Item 30, Chapter 3, Section I)
Wrench, fixed, open end (Item 3, Chapter 3, Section I)
SUPPLIES:
Pencil
Seven tags
Lockwire (10 in.) (Item 61, Appendix D)
Glyptol (Item 39, Appendix D)
Gasket (7084278)
PERSONNEL:
Two
REFERENCES: TM 5-5420-226-10
PRELIMINARY PROCEDURES:
Remove powerplant (page 5-2)
Remove starter low voltage relay
solenoid (page 10-227)
TA168672
Go on to Sheet 2
