TM 5-5420-226-20-3
MASTER CONTROL PANEL REPAIR (Sheet 39 of 73)
Circuit Breaker Replacement (Sheet 7 of 7)
REMOVAL; CIRCUIT BREAKER (G):
Using fingers, disconnect two electrical connectors from rear of circuit breaker (A)
1.
by pulling out.
2.
Using cross-tip screwdriver, remove two screws (B) and lockwashers (C) securing circuit
breaker (A) to panel.
Remove circuit breaker (A).
3.
INSTALLATION: CIRCUIT BREAKER (G):
Place circuit breaker (A) in position
1.
on panel.
Using cross-tip screwdriver, install
2.
two screws (B) and lockwashers (C)
securing circuit breaker (A) to panel.
Apply silicone compound to two male
3.
electrical connectors for circuit breaker
(A).
4.
Using finpers, connect two electrical
connectors in rear of circuit breaker
( A).
5.
Install panel in vehicle (page 10-36).
End of Task
TA168727