TM 5-5420-226-20-3
FINAL DRIVE STUD REPLACEMENT (Sheet 2 of 2)
INSTALLATION:
1.
Using clean brush, lightly coat tapped stud
holes (A) with primer.
2.
Using clean brush, lightly coat threads of
studs (B) with sealing compound.
NOTE
Any stud installed in area (C) must protrude
2-15/16 inches out of tapped stud hole.
Any stud installed in area (D) must protrude
2-1/4 inches out of tapped stud hole.
3.
Thread two hex nuts on new stud and jam the
nuts. Using 1-1/2 inch wrench on top nut.
install new-stud (B).
Install final drive (page 12-4).
4.
End of Task
12-11